PRB08031T2 Jet Jam Pool Racer Manual

• Fully dry the inside and outside of the boat.
• Remove the hatch before storing your boat.
• Repair any damage or wear to the boat.
• Lubricate the driveshaft using ProBoat
Marine Grease (DYNE4200).
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions.
NOTICE: When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as a
car. Doing so can damage the boat.
After Boating and Maintenance
Binding
The included transmitter and receiver are bound at
the factory. If you need to rebind, follow the instructions
below.
1. Power ON the boat. The receiver LED will blink.
2. Power ON the transmitter. The receiver LED will go
solid, indicating it is bound.
If you encounter problems, follow binding instructions
and refer to the troubleshooting guide for other
instructions. If needed, contact the appropriate Horizon
Product Support office.
NOTICE: Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in
bind mode within 400 feet. Doing so may result in
unexpected binding.
Failsafe
In the unlikely event that the radio connection is lost
during use, the receiver will drive the servos to their pre-
programmed failsafe positions as set during BINDING.
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode.
When the transmitter is powered on, normal control is
resumed.
IMPORTANT: Failsafe activates only in the event
that signal is lost from the transmitter. Failsafe will
NOT activate in the event that receiver battery power
decreases below the recommended minimums or
power to the receiver is lost.
• Prolong motor life by preventing overheating
conditions.
• Regularly lubricate (DYNE0100) the bushings on each
end of the motor and more frequently when the
motor is wet. Failure to do so may cause the motor
shaft to seize in the bushings.
• Use water displacement fluid to flush any water from
the motor compartment.
Motor Care
9
EN
12
-
INCH READY
-
TO
-
RUN POOL RACER