Miss 1/8-Scale Miss Elam Unlimited Hydroplane. Owner's Manual Specifications Length........................................................................................45.25 in (1131.3mm) Beam............................................................................................ 23.75 in (593.8mm) Engine.................................................................Zenoah G26M and Tuned Exhaust Speed.................................................................................................
Introduction It is very important that you operate this boat responsibly. With proper care and maintenance, you will be able to enjoy your Miss Elam for many years to come. Congratulations on the purchase of your . Pro Boat™ Miss Elam. This is a 1/8-scale replica of the world famous full-scale hydro. You are just minutes from one of the most thrilling experiences the radio control hobby has to offer. Carefully unpack your Miss Elam and examine the boat and its contents.
Limited Warranty & Limits of Liability (cont) event that you may need any assistance. For questions or assistance, please direct your email to productsupport@ horizonhobby.com, or call 877.504.0233 toll free to speak to a service technician. Inspection or Repairs If this Product needs to be inspected or repaired, please call for a Return Merchandise Authorization (RMA). Pack the Product securely using a shipping carton.
Section 1: Building the Boat Stand Parts Required Plywood boat stand pieces (4) Tools and adhesives needed for completion CA or epoxy Section 3: Removing the Canopy Unscrew the 2 knurled hatch-mounting screws from the rear of the hatch. Lift the hatch from the boat. m 1. Attach the side boat pieces by interlocking them into the end pieces as shown. m 2. Secure the interlocking boat stand with medium-thick CA or epoxy.
Section 4: Installing the Radio System Batteries (cont) Section 5: Installing the Rudder Parts Required Rudder 2.5mm hex screw Tools and Adhesives Required 2.5mm hex driver m 1. Locate the stainless steel rudder and . 2.5mm hex screw. m 4. Plug the switch harness into both the receiver and the battery box following the instructions provided with the radio. Secure the radio box cover with the hex head screws. m 3. Find the flat spot on the rudder. Put screwlocking compound on the 2.
Section 7: Fueling the Tank Use only Zenoah® 2-cycle synthetic oil and gasoline mixed 32:1 to power the Miss Elam. Keep the fuel in a moisture-free environment, as stale fuel will cause the Zenoah G26M engine to lose performance. Section 10: Starting the Engine Note: The Zenoah® G26M carburetor is factory adjusted to deliver optimum performance. See the Zenoah Engine manual for fine-tuning adjustments and other helpful information to make your RC boating experience trouble-free.
Section 11: Initial Launch of the Miss Elam With the transmitter antenna up, maneuver the Miss Elam in an oval, turning only to the right at slow to medium speeds. Make certain that the boat and radio system are functioning correctly. Section 13: Cooling System If at anytime you notice the boat and/or radio system are not functioning correctly, end the operation of the boat immediately and do not run the boat again until you are confident the problems have been corrected.
Section 15: Troubleshooting Guide Section 14: Clutch The centrifugal clutch automatically engages when the engine rpm is increased. Be sure that the idle speed adjustment is set low enough so that the propeller does not rotate at idle.
Section 17: Maintenance (cont) Section 18: Replacement Parts Your local hobby store should carry a good supply of Miss Elam replacement parts. You can also purchase these parts from Horizon Hobby at www.horizonhobby.com or call toll-free 1-800-338-4639. Simply follow the instructions below to properly lubricate your drive shaft. Pro Boat recommends PRB0100 Grease Gun with Marine Grease. m 1. Carefully note how the entire drive shaft is installed. This is pivotal in order to properly .
Appendix Spark Plug PRB2556 Notes PRB2264 Pull Start PRB2273 PRB2563 Carburetor Primer Button PRB2563 PRB2275 PRB2651 PRB2283 PRB2252 Carburetor PRB0153 PRB2254 PRB2952 18 PRB2278 19
www.ProBoatModels.com © 2007 Horizon Hobby, Inc.. 4105 Fieldstone Road. Champaign, Illinois 61822. (877) 504-0233. www.horizonhobby.com Printed in China 8956.