User Manual

ManualsBrandsPro Boat ManualsHobbyMiss Geico 29" V3 Brushless Catamaran RTR

29 INCH RTR BL CATAMARAN V3

Canopy Removal

1. Push down and turn the latch button one quarter of a

turn to disengage the pin from the hull.

2. Carefully lift the rear of the canopy and pull back to

disengage the front pin from the hull.

Battery Charger

Choose a charger designed to charge the recomended

Dynamite

Reaction 7.4V 5000mAh 2S 50C Li-Po battery.

We recommend either the Dynamite

Prophet

™

Sport

Plus 50W AC/DC Charger or the Dynamite Prophet Sport

Duo 2 X 50W charger. Refer to your charger manual for

charging instructions and safety information.

NOTICE: Never charge a battery in the boat or damage

may result.

Low Voltage Cutoff (LVC)

Discharging a Li-Po battery below 3V per cell may

damage your battery.The included ESC protects the boat

battery from over-discharge using Low Voltage Cutoff

(LVC). Before the battery charge decreases too much,

LVC removes power supplied to the motor. Power to

the motor pulses, showing that some battery power is

reserved for boat control and safe landing.

Disconnect and remove the Li-Po battery from the boat

after use to prevent trickle discharge. Charge your Li-Po

battery to about half capacity before storage. During

storage, make sure the battery charge does not fall below

3V per cell. LVC does not prevent the battery from over-

discharge during storage.

NOTICE: Repeated operation to LVC will damage the

battery.

Tip: Monitor your boat battery's voltage before and

after boating by using a Li-Po Cell Voltage Checker

(DYN4071, sold separately).

Installing the Battery Packs

1. Install the 2 battery packs opposite each other in the

compartment. Secure with the hook and loop straps. If

running your boat in rougher water conditions, the use

of Waterproof Hook and Loop Tape (DYNK0300) may

also be needed to fully secure your batteries' positions.

Tip: Move the packs forward or back to adjust the

center of gravity for your boat. Move the packs toward

the bow so the bow rides lower in the water. Move

the packs away from the bow so that the bow rides

higher in the water.

2. Connect each battery pack to the ESC power

connectors.