Owner's manual

Section 7: Starting the Engine

Section 6: Fuel/Oil Mixture

Parts Needed

Ratio Rite

™

measuring cup

Unleaded gasoline

Zenoah

2-stroke oil

Step 2. Remove the fuel tank cap and fill the fuel tank with

the gasoline and oil mixture. Use a funnel to prevent spills.

If you do spill, be certain to immediately wipe it up with a

clean towel or rag.

Step 1. Mix gasoline and 2-stroke oil (ZEN20001) at a mixing

ratio of 32 : 1 (gas to oil) using the Hangar 9

Ratio Rite

Mixing Cup (HAN3101).

Step 1. Read the included Zenoah

G23 marine engine

manual thoroughly to become familiar with the proper care

and operation. Do not attempt to operate this engine until

you have read the engine manual thoroughly.

Step 2. Turn the radio system on (transmitter first, then

the receiver.)

Step 3. To start the engine, push the priming bulb located on

the carburetor three to four times to prime the engine. If the

engine is warm, there should be no need to prime the engine.

Step 4. Open the throttle trim to an approximate position of

1/3 to 1/2 open. (See radio manual.)