User Manual

Recoil

Trim Tab Adjustment

Tip: Ensure the trim tab panels are parallel to the bottom

of the boat.

You may desire to bend the trim tabs for wind and water

conditions. To adjust the angle of the trim tabs, use a large

pair of pliers to bend the tabs. This must be done carefully

so that you do not damage the hull.

Trim Fin Adjustment

NOTICE: Carefully handle the sharp trim fins, which can

cause injury or damage.

1. Loosen and tighten the fins on the mount using a hex

wrench and a pair of pliers.

2. Adjust the turn fin angle so that the tip of the turn fin is

parallel but not lower than the keel of the boat.

Water Cooling System

If water does not stream out of the water outlets while

the boat is moving forward, immediately stop the boat

and clean the obstruction from the water cooling system.

1. Disassemble and clean the water cooling system to

remove blockage and prevent overheating.

2. Replace any damaged parts.

CH4

CH3

CH2

CH1

B/C

Failsafe

Failsafe positions are also set during binding. In the

unlikely event that the radio link is lost during use, the

receiver will drive the servos to their preprogrammed

failsafe positions. If the receiver is turned on prior to

turning on the transmitter, the receiver will enter failsafe

mode. When the transmitter is turned on, normal control

is resumed. For more information on setting the failsafe,

refer to the Binding section above.