User Manual

ManualsBrandsPro Boat ManualsHobbyRecoil 17" Brushless Self-Righting Deep-V RTR

Recoil

When You Are Finished

Tip: Always remove the canopy before storage or

moisture may allow mold and mildew to grow in the boat.

Drain water from inside the hull using the drain plug.

• Fully dry the inside and outside of the boat, including

the water cooling lines and jacket around the motor

• Remove the hatch before storing your boat

• Repair any damage or wear to the boat

• Lubricate the drive shaft using Dynamite Marine

Grease (DYNE4200)

• Make note of lessons learned from the trimming of

your boat, including water and wind conditions

Tip: The hook and loop strips in the boat retain water.

To dry them, press on them with a dry cloth.

NOTICE: When you are finished boating, never leave the

boat in direct sunlight or in a hot, enclosed area such as a

car. Doing so can damage the boat.

1. Power off the receiver.

2. Power off the transmitter.

3. Disconnect and remove the

battery from the boat.

1 2

Maintenance

Drivetrain Lubrication

Always replace the drivetrain parts when they are damaged

or show visible wear or injury and damage may result.

Lubricating the drive shaft is vital to the life of the

drivetrain. The lubricant also acts as a water seal, keeping

water from entering the hull through the stuffing tube.

Lubricate the drive shaft, propeller strut and all moving

parts after 30 minutes of operation.

1. In the hull, use a 2mm hex driver to loosen the

setscrew (A) holding the drive shaft (B) in the

motor coupling (C).

2. Remove the drive shaft by sliding it from the back of

the boat.

Tip: Use paper or cloth when handling the flex shaft

and other lubricated parts.

3. Wipe the old lubricant and material from the drive

shaft.

4. Lubricate the full length of the drive shaft assembly

up to the drive dog using marine grease (DYNE4200).

5. Carefully reinstall the drive shaft, ensuring that there

is a 1 mm gap between the stuffing tube and the

drive dog.

6. Align the flat spot on the drive shaft with the set

screw in the coupling. Apply threadlock to the

coupling setscrew and tighten it with a 2mm hex

driver.

NOTICE: Running the boat in saltwater could cause some

parts to corrode. If you run the boat in saltwater, rinse it

thoroughly in freshwater after each use and lubricate the

drive system.

NOTICE: Because of its corrosive effects, running RC

boats in saltwater is at the discretion of the modeler.