User Manual

Recoil

Propeller Service

1. Use an 5.5mm nut driver to loosen the nut (A) from

the driveshaft (B).

1. Remove the nut and propeller (C) from the driveshaft.

2. Assemble in reverse order. Correctly align the

propeller with the drive dog on the driveshaft.

Rudder Trim

If the boat does not go straight, adjust the ST TRIM dial

on the transmitter.

If you are using all the steering trim on your transmitter

to make the boat drive straight, return the trim to neutral

and mechanically center the rudder. To do this, loosen

the hex nut (A) from the rudder horn (B), then adjust the

linkage (C) until the rudder is properly centered.

Rudder Service

1. Loosen the setscrew (A) on the rudder arm using

a 1.5mm hex wrench, then remove the linkage (B)

from the rudder arm.

2. Loosen the setscrew (C) from the rudder pin (D) using

a 1.5mm hex wrench.

3. Turn over the boat and lightly tap the rudder to

remove the pin.

4. Assemble in reverse order.