PRB08033 Pro Boat Valvryn F1 RTR Manual

Valvryn™ 25
Rudder Trim
If the boat does not go straight, adjust the steering trim
dial on the transmitter.
1. Use a 1.5mm hex driver to loosen the set screws on
the 2 servo swivel barrels.
2. Adjust the linkage until the rudder is centered.
3. Use a 1.5mm hex driver to tighten the 2 servo swivel
barrels.
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of a
single specific transmitter. The STX2
®
transmitter and
SPMMRX200 receiver are bound at the factory. If you
need to rebind, follow the instructions below:
1. Insert the Bind Plug in the BIND port of the receiver.
2. Connect a fully charged battery to the ESC.
3. Power on the ESC. The red receiver LED flashes,
indicating the receiver is in bind mode.
4. Center the ST TRIM and TH TRIM dials on the
transmitter.
5. Turn the Steering Wheel to Full Right. Power ON the
transmitter while holding the Steering Wheel
to the Right.
6. Release the Steering Wheel when the receiver LED
goes solid.
7. Remove the Bind Plug and store it in a convenient
place.
8. Power OFF the ESC to save the settings.
9. Power OFF the transmitter.
You must rebind when:
• You want different failsafe positions
(e.g. when throttle or steering reverse has
been changed).
• Binding the receiver to a different transmitter.
NOTICE: Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in
bind mode within 400 feet. Doing so may result in
unexpected binding.
Binding
Failsafe
In the unlikely event that the radio connection is lost
during use, the receiver will drive the servos to their pre-
programmed failsafe positions (normally no throttle and
straight steering).
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode. When
the transmitter is powered on, normal control is resumed.
11
EN