PRB08033 Pro Boat Valvryn F1 RTR Manual

Valvryn™ 25
The radio system is calibrated to the ESC at the factory. To
calibrate to a different radio or ESC, follow these steps:
1. Remove the propeller.
2. Ensure that the throttle trim is neutral.
3. Power on transmitter.
4. Move the transmitter’s throttle lever to full throttle,
holding that position.
5. Press the power button to turn on the ESC while holding
full throttle on the transmitter.
6. The ESC will emit 2 tones, acknowledging full throttle.
7. Return the throttle to a neutral position. The ESC will
emit one tone.
8. Move the transmitter’s throttle lever to full reverse. The
ESC will emit 3 tones.
9. Return the throttle to a neutral position. The ESC is now
calibrated to the transmitter throttle range.
CAUTION: Never change the battery chemistry to NiMH
when using a LiPo battery. Damage to the battery will
occur, which could result in a fire.
ESC Calibration
12
EN
The black-shaded setting is the factory default
Programmable Items
Programmable Value -B Single Beep B–– Long Beep
-B -B-B -B-B-B -B-B-B-B B––
B––
-B
B––
-B-B
B––
-B-B-B
Running Mode -B
Forward
Only
Forward/
Backward
Li-Po Cells -B-B
Auto
Calc.
2s 3s
Low Voltage Cutoff -B-B-B None 2.8V/Cell 3.0V/Cell 3.2V/Cell 3.4V/Cell
Timing -B-B-B-B 0.00º 3.75º 7.50º 11.25º 15.0 18.75º 22.50º 26.25º
1. Pull and hold the Throttle Trigger to full throttle and turn
the ESC on.
2. After 2 seconds a “-B-B” will sound. Wait another 5
seconds and the ESC will give a rising tone to indicate
you have entered Programming Mode.
3. After entering Programming Mode, you will hear 4 tones
in a loop, indicating Programmable Items. Push the
Throttle Trigger to full brake within 3 seconds after the
tone sounds matching the programmable item you want
to select.
4. After selecting a programmable item, you will hear
several tones in a loop indicating Programmable Values.
Pull Throttle Trigger to full throttle to select the value
matching the tone. The ESC will give an alternating tone
to indicate the item is selected.
5. Keep the trigger in Full Throttle to return to Step 3 and
continue item selection. Move the throttle to full brake
position within 2 seconds to exit the Program Mode.
NOTICE: Maximum voltage is 12.6V.
ESC Programming with Transmitter