User`s guide

TIPS IN THE FIELD cont.
9
5.) DO NOT hammer or slam the camera into pipe
where it is just not pushing through. Use the technique
described on tip 4. After you are comfortable with your
system it may be easier to push thru the pipe fast and
slowly pull back for your actual inspection. Pulling the
camera back is always easier than pushing it through
6.) Pro-Built tool sysems have an automatic light
adjustment. If the automatic light adjustment is not
enough due to unusual circumstances in different or
difficult pipe use your dimmer control knob to adjust for
better picture quality.
7.) This camera is made to function through several
bends and 90 degree angles. If it is resisting in any
T or P-Trap do not force the unit. If you do manage to
get through a tough T be careful not bend the camera
head back on itself, as it may cause damage to the unit.
8.) After using your camera in a pipe pull it out and wipe
the cable and head down with a moist warm towel and
regular household detergent or soap. This will keep your
equipment functioning longer.