Owners manual

10
51088
Revised
12.1.05
from the pitman and idler arm studs.
28. Detach the anti-sway bar mounts from the frame. Re-install, sway bar flipped over from the
original position.
29. On the driver side lower A-arm pocket, carefully cut the rear section out using the weld in plate
(PN 96-1313) and ILLUSTRATION 4 & 5 as a guide.
1. Tack the weld in plate (PN 96-1313) to the back of the pocket. DO NOT finish welding until
the front differential has been reinstalled to ensure there is adequate clearance between the differen-
tial and the frame. See ILLUSTRATION 4 & 5.
2. Loosely install the driver side differential drop (PN 90-3012) into the OEM location with the
OEM nut and bolt. ILLUSTRATION 6.
3. Assemble pass side differential drop (PN 90-1261) using bushings and sleeves ( PN 15-11148
FRONT INSTALLATION:
PN 90-2014
PN 90-2055
PN 90-2014
Detail of PN 90-4036
Taper Orientation
Detail of PN 90-4053
Steering link
Orientation
Front of vehicle
1/2” X 2 3/4”
Bolts
OEM Hardware
Illustration 8
Steering Drop
1/2” X 4” Bolt
Stabilizer
Mount
Factory
Center Link
1/2” X 4”
Bolt
Center Link Drop
PN 90-2354
Center Link Drop
PN 90-2354