Owners manual

13
51947/51947MX
Revised
7.31.08
10mm X 60mm Bolts (6)
Illustration 11
CV Spacer Install
90-4077 CV
Spacer
Outer CV
Axle
CV
spacer
ring
(90-3809)
balls.
52. Install the new Pro Comp coil over shock
(624000) to the coil over mount upper bracket (90-
3712) with the supplied 1/2” X 2 3/4” hardware
from hardware pack (90-6318).
53. Install the 1/4” spacer (90-3956) onto the upper
coil over mount upper bracket studs. See ILLUS-
TRATION 12.
NOTE: Be sure that the locating tab on the
coil spacer is facing toward the outside of the vehicle.
54. Fasten upper bracket to the vehicle using the sup-
plied 7/16” hardware on the top from hardware
pack (90-6317) and torque to 45-50 ft./lbs. See
ILLUSTRATION 12.
55. Secure the lower coil over shock cross pin to the
lower A-arm using the supplied 7/16” X 2 1/2”
bolts and hardware. Torque according to the chart
on page 19. See ILLUSTRATION 12.
NOTE: Supplemental instructions for MX
coil over installation are located in box 51947BMX-
6/51957BMX-1.
56. WITH THE STRUT SPACERS
, attach the strut
spacer (90-2614) to the top of the strut using the
OE hardware. Torque to manufacturers specifica-
tions.
57. Fit the strut and spacer assembly into the stock
mounting locations. Fasten using the supplied
hardware on the top from hardware pack (90-
6317) torque to 45-50ft./lbs. See ILLUSTRA-
TION 5.
NOTE: Be sure that the locating tab on the
Illustration 9
Rear Crossmember
OE Bolt
90-3688 Rear
Crossmember
Illustration 10
Lower A-Arm Install
5/8” X 4
1/2” Bolt
5/8” X 5
1/2” Bolt