Owners manual

21
51947/51947MX
Revised
7.31.08
Comp springs, PN 14157.
NOTE: If the factory spring has a rub-
ber pad remove it and install it on to the new
spring.
22. You may have to release some slack in the
differential vent hose by lightly pulling the
excess down from the frame.
23. Repeat this procedure on the remaining side
of the vehicle.
24. Raise the rear end until the new Pro
Comp shock absorbers, (927543 or
MX6105), can be installed. Ensure
that the new springs are seated prop-
erly.
25. Using the OE bolt, install the brake
line relocation bracket (90-55089-4) to
the OE brake line mount position as
shown in ILLUSTRATION 21. Bolt
the OE bracket to the new relocation
bracket using the 5/16” X 1” bolt, nut,
and washer provided.
26. Using ILLUSTRATION 20 as a refer-
ence, install the track bar relocation
adapter (90-5400). Place the adapter
into the OE mount and use the OE
bolt to hold it in place. On the passen-
ger side of the adapter are two holes that are
used as drill guides for a 7/16” drill. Drill
completely through the OE mount and install
the 7/16” X 1 1/4” bolts, nuts, and washers
provided. Torque these bolts to the bolt
specifications in the rear of this manual.
27. Install the track bar into the newly installed
adapter using the provided 9/16” X 3 1/2”
bolt, nut and washer. Torque these bolts to
the bolt specifications in the rear of this man-
ual.
28. Install the sway bar using the new end links
(90-2311). Use the bushings and sleeves
from (90-6235). Use the OE bolt and nut on
the top and use the hardware from pack (P-
843) on the bottom. Torque these bolts to the
bolt specifications in the rear of this manual.
See ILLUSTRATION 24.
29. Torque all fasteners.
30. Install your wheels and tires, then lower the
vehicle to the ground.
NOTE: Remove OE rotor/drum retaining
clips from wheel studs before installing the
wheels.
31. With the vehicle on the ground and Tighten
control arm bolts to OE specifications.
Hardware
From Hardware
Pack P-843
90-2311
OE Bolt & Nut
Illustration 24
Passenger Side
OE Bolt & Nut
OE parking
brake cable
90-1785
9/16” X 4”
9/16” X 3 1/2”
Illustration 25
Driver’s side