Owners manual

7
51947/51947MX
Revised
7.31.08
⇒ Read the instructions and study the illustrations before attempting the installation.
⇒ Separating the parts according to the areas where they will be used and placing the hardware with
the brackets before you begin will save installation time.
⇒ Check the parts and hardware against the parts list to assure that your kit is complete.
⇒ ALWAYS wear safety glasses when using power tools or working beneath your vehicle.
⇒ Always use NEW cotter pins on re-assembly! (These items are NOT supplied)
Before You Begin:
Important!
• Front end and head light realignment is necessary!
• Speedometer and ABS recalibration will be necessary if larger tires (10% more than stock
diameter) are installed.
⇒ Due to differences in manufacturing, dimensions and inflated measurements, tire and
wheel combinations should be test fit prior to installation. Tire and wheel choice is
crucial in assuring proper fit, performance, and the safety of your Pro Comp
equipped vehicle. For this application, we recommend a 17” or larger wheel not to
exceed 8” in width with a maximum backspacing of 5” must be used. Additionally, a
quality tire of radial design, not exceeding 35” tall X 12.5” wide is also recom-
mended. Please note that the use of a 35” X 12.5” tire will require modification to
the front fender and front bumper support (see step 85-98 in the instructions). Viola-
tion of these recommendations will not be endorsed as acceptable by Pro Comp Sus-
pension and will void any and all warranties either written or implied.
COIL OVER UPGRADE KIT: 51957
Also, check out our outstanding selection of Pro Comp tires to
compliment your new installation!
Optional Equipment Available from your Pro Comp Distributor!
NOTE: REAR COIL SPACERS PN 55496 ARE NOT TO BE INSTALLED
IN CONJUNCTION WITH REAR COIL SPRINGS PN 14157