Owners manual

52612

Revised

8.21.07

8) Install 90-1241 radius arm bracket and spacer using the factory hardware. (See Illustration 1)

Torque mounting hardware to 65 ft. lbs.

9) Install radius arm into bracket and install pivot bolt. It will be necessary to raise the I-Beam to

align the bolt holes in the bracket with the radius arm sleeve. DO NOT TIGHTEN PIVOT BOLT

AT THIS TIME.

* * REPEAT STEPS 7 - 9 ON DRIVER SIDE * *

10) Remove I-Beam pivot bolts on both sides. Raise or lower the I-Beams to remove the bolts

without damaging the threads.

11) Remove the I-Beam pivot brackets from the cross member. Make note of hardware location.

All hardware will be reinstalled in the hole it was removed from.

12) Install the passenger I-Beam pivot bracket 90-1248 using the existing bolt plate and the 1/2” x

2-3/4” bolt into the factory holes. DO NOT TIGHTEN ANY HARDWARE. (See Illustration 2)