Owners manual

52612
Revised
8.21.07
13) Install the driver I-Beam pivot bracket 90-1245 using the existing hardware. DO NOT
TIGHTEN ANY HARDWARE. (See Illustration 3)
14) Install the pivot strut 90-2120 between the passenger and driver pivot brackets and hold it in
place with the 9/16” x 3-1/2” bolts provided. DO NOT TIGHTEN ANY HARDWARE.
15) Begin to tighten I-Beam pivot bracket hardware. Rotate back and forth from one bracket to
the other one bolt at a time. This will position the pivot brackets in the proper location. If not
properly located, the I-Beam pivot bolt will be in a bind and installation of the I-Beams and pivot
strut will be difficult.
16) Once the pivot bracket hardware is tight, remove the 9/16” bolts and the pivot strut. The bolts
should remove with ease. If not, repeat Step #14, paying close attention to the location of the pivot
brackets.
7