Owners manual

24612 Bronco/Standard Cab Coil Spring (6” Lift) pair 1

24613 Extra Cab Coil Spring (6” Lift) pair 1

319510 Front Shock Absorber (4” Lift) 2

321510 Front Shock Absorber (6” Lift) 2

326500 Rear Shock Absorber 2

13130 Rear Add-A-Leaf Kit 1

532 Adjustable Camber/Caster Bushing 1

(4WD) 2-3/4”

7325 Stainless Brake Hose Kit (3 pc.) 90’-96’ 1

7330 Stainless Brake Hose Kit (3 pc.) 82’-89’ 1

FD400 Pitman Arm 1

PRIOR TO INSTALLATION:

 Check the VEHICLE FRAME for any damage or severe corrosion. If there is any doubt as to the

condition of the chassis, have the vehicle checked by a state approved alignment specialist. If there

is any structural damage, do not install this kit.

 Check the ALIGNMENT to insure that it falls within factory specifications. The installation of this

kit will not change the alignment of the vehicle more than +/- 1/2 from factory specifications. If the

vehicle can not be brought to within factory specifications, (2) adjustable camber/caster bushings #532

(4WD only) may be required.

 Read the instructions carefully and study the illustrations before attempting installation. Pro Comp

Suspension is not responsible for damage, failure, or injury resulting from improper installation of this

kit.

 Installation of the kit should take approximately 10-14 hours. Installation by a professional

mechanic is recommended. Proper use of the appropriate power tools and the use of a shop hoist

can greatly reduce installation time.

 Check the parts and hardware against the parts list to assure that your kit is complete. Report any

shortages to PRO COMP at 800-776-0767. The parts and hardware supplied are of high grade mate-

rial and must not be replaced by inferior parts or failure may result. Pro Comp Suspension is not

responsible for damage, failure or injury due to improper installation or part substitution.

 Separate parts according to the areas where they will be used. Placing the hardware with the

brackets before you begin will save installation time.

 All components in this kit come with a protective coating. Do not plate (i.e. chrome, cadium, zinc

etc.) or otherwise alter the finish in any way. This could weaken the structural strength of the compo-

nents.

 This kit is supplied as a bolt-on assembly. Do not weld anything to the components and do not

weld the components to the vehicle.