Owners manual

 Foot pound torque readings are listed on the Torque Specifications Chart at the end of the instruc-

tions unless specifically stated in an instruction. Apply loctite retaining compound on all bolts during

installation. A drop on the exposed threads of a bolt before installing the nut will provide an adequate

bond. Unless otherwise specified, all bolts should be installed with a flat washer at both ends. Loctite,

then torqued to specifications. DO NOT USE AN IMPACT WRENCH TO TIGHTEN ANY OF THE

BOLTS.

 Recheck brake/steering systems. Be sure all hoses are long enough. Make sure there are no

clearance/bindings problems.

 Using the brake line support kit (90-6029), position brake lines so they do not make contact with

any moving parts. Hoses must be able to slide unrestricted through the grommets provided.

 The following tools will be required for the proper installation of this kit:

Pitman Arm Puller Wire Brush

Right Angle Drill and Short Drill Bits Hammer

1/2” Drive Ratchet and Sockets File

1/2” Drive Breaker Bar Centerpunch

Assorted Combination Wrenches Hydraulic Floor Jack

Heavy Duty Jackstands

 Always wear safety glasses when using power tools.

 It is recommended that you purchase new radius arm bushings from your Ford dealer. (Part #

E7TZ-3B203-A) See ILLUSTRATION 2 for breakdown.

 Steam cleaning or pressure washing the front suspension and frame of the vehicle will make the

installation cleaner and more trouble free.

 Park the vehicle on a level concrete or asphalt surface. Set the parking brake, secure and prop-

erly block vehicle prior to beginning installation.

TIRE NOTE:

Tire and wheel choice is crucial in assuring proper fit performance and the safety of your Pro Comp

equipped vehicle. For the following applications the tire and wheel sizes listed are the optimum fit-

ment. Any other sizes, either smaller or larger will not be endorsed as acceptable by Pro Comp

Suspension and will void any and all warranties, written or implied. In addition Pro Comp recom-

mends a quality tire of radial design.

LIFT TYPE TIRE SIZE RIM SIZE

4” 2WD 31” x 10.515 or 16 x 8 with 3.5 backspacing

6” 2WD 33” x 12.515 or 16 x 8 with 3.5 backspacing

4” 4WD 33” x 12.515 or 16 x 8 with 3.5 backspacing

6” 4WD 35” x 12.515 or 16 x 8 with 3.5 backspacing

PLEASE NOTE: Depending on year of vehicle minor fender/bumper trimming may be necessary.