Owners manual

10
57095
Revised
2.28.2008
17) Next, position front crossmember (90-1332) into existing lower front a-arm mounting locations
(ILLUSTRATION 17) using 3/4” x 4 1/4” hex bolts, locating washers (90-1345) and 3/4” top lock nuts;
fasten loosely.
18) Lower differential slowly onto the front crossmember mounting cushions and rear crossmember
mount. Make sure to check clearances around differential and area where rear crossmember section was
cut away. Also, check to make sure that electrical wiring and tubing do not bind.
REAR CROSSMEMBER,
90-1354
CROSS-
MEMBER
SUPPORT
BRACKET,
90-1344
EXISTING
REAR CROSSMEMBER
HEX BOLT, 3/4” X 4 1/4” LG.
LOCATING WASHERS
FRO
NT
OF
V
E
H
I
CL
E
TOP LOCK NUT, 3/4”
ILLUSTRATION 15
EXISTING REAR
CROSSMEMBER
NYLOC NUT, 1/2”-13
FLAT WASHER, 1/2”
SPLIT LOCK WASHER, 9/16”
HEX BOLT,
14MMX25MM
FLAT WASHER, 1/2”
HEX BOLT,
1/2” X 2-1/2”
STEERING BOX
SUPPORT
BRACKET,
90-1336
REAR
CROSSMEMBER,
90-1354
ILLUSTRATION 16