Owners manual

15
57095
Revised
2.28.2008
the 1/2” nut attaching spindle spacer to spindle to 90 ft./lbs. and the steering arm nut to 83 ft./lbs.
28) Place rotors on hubs. Attach brake calipers to spindle. Fasten using existing hardware. Torque
to 90 ft./lbs.
29) Remove stock brake lines and replace with required new longer brake line kit, part # 7213. Fas-
ten following installation instructions in kit. Make sure that brake lines are positioned so they do not make
contact with any moving parts.
30) Attach O.E.M. coil and shock to the new shock spacer (90-4014) using existing hardware. Torque
to 47 ft./lbs. Next install shock spacer assembly into upper mount (ILLUSTRATION 26) using the 7/16”
hardware provided. Install lower a-arm. Torque lower shock mount to 101 ft./lbs. and 7/16” hardware to
ILLUSTRATION 25
F
RO
N
T
O
F
V
E
H
I
C
L
E
HEX BOLT, 1/2” X 2 1/4” LG.
FLAT WASHER 1/2” A.N.
SPINDLE SPACER, 90-4013
FLAT WASHER, 5/16” A.N.
SET SCREW,
3/8” X 1 1/2”
TOP LOCK NUT, 5/16”
JAM NUT, 3/8”
FLAT WASHER, 1/2” A.N.
SPINDLE SUPPORT
BRACKET,
90-1328 (PASS.)
90-1329 (DRVR.)SHOWN
TOP LOCK NUT, 1/2”
U-BOLTS
IN PART PACK 020100
FRONT HUB ASSEMBLY
EXISTING