Owners manual

16
57095
Revised
2.28.2008
60 ft./lbs.
31) Install sway bar drop brackets (90-1339,
Pass./90-1340, Drvr.) to existing sway bar upper
mounting locations using existing hardware.
(ILLUSTRATION 27). Torque hardware to 19 ft./lbs.
32) Install sway bar to sway bar mounting brackets
with spacer (90-1508) installed as illustrated, using the
5/16” hardware provided. Do not tighten. Locate
lower sway bar mount on lower a-arm. Fasten using
existing hardware; torque to 51 ft./lbs. Torque 5/16”
hardware to 21 ft./lbs.
33) Install skidplate (90-1369) using 3/8” hardware
provided (ILLUSTRATION 28). Torque to 25 ft./
lbs.
34) Install wheels and tires. Lower vehicle to ground.
Tighten axle nut using 35mm socket to 174 ft./lbs.
Attach locking cap, cotter pin and replace the dust cover.
35) Using your floor jack, raise the rear of the vehicle until the tires are off the ground. Support the vehi-
cle using floor jacks on the vehicle frame in front of the rear axle. Carefully lower the floor jack and re-
move it from the work area.
36) Remove the wheels.
37) Remove the OEM brake lines and re-
place them with the new brake lines #7213.
Be very careful and do NOT let the master
cylinder run dry! With ABS brakes this situa-
tion will damage the system.
38) Remove the OEM shock absorbers.
39) Locate the ABS wiring harness located
across the top of the differential housing.
Disconnect the harness connector at the
frame and remove the mounting loom from
the gas tank flange. Carefully secure this
harness out of the way to avoid damage.
40) Disconnect the ABS valve link from the
differential housing. (ILLUSTRATION 29)
ILLUSTRATION 26
NYLOC
NUT,
7/16”
FLAT WASHER,
7/16”
UPPER A-ARM
SHOCK SPACER,
90-4014
SHOCK
ABSORBER
EXISTING
PASSENGER SIDE
ILLUSTRATION 27
F
R
O
N
T
O
F
V
E
H
IC
L
E
EXISTING
SWAY-BAR
HARDENED FLAT
WASHER, 5/16”
TOP LOCK NUTS, 5/16”
GD. 8 HEX BOLT,
5/16” X 1” LG.
EXISTING
HARDWARE
SWAY BAR
DROP
BRACKET
90-1339
(PASS.)
90-1340
(DRVR.)