Owners manual

18
57095
Revised
2.28.2008
41) Disconnect the emergency brake cables from the brake drum backing plates. (Both sides).
42) On the driver side of the vehicle at the rear of the gas tank, remove the emergency brake cable
bracket from the gas tank clamp. See ILLUSTRATION 30.
43) While supporting the gas tank, remove the gas tank retaining bolt and swing the gas tank clamp
down, reroute the above mentioned cable outside and below
the clamp as seen in ILLUSTRATION 31. Reattach the gas
tank clamp.
44) Carefully rotate the emergency brake cable bracket 180
degrees and reattach the cable to its original mount. See IL-
LUSTRATION 30 and 31.
45) Working on one side of the vehicle at a time: Support the
side you are working on with the floor jack, remove the U-bolts
from the differential mount pad and carefully lower the housing
enough to insert the lift block. These blocks are slightly tapered
and the short side of the taper is oriented to the front of the ve-
hicle. Install the U-bolts supplied, and tighten just enough to
keep this side in place. Leaving the u-bolts slightly loose will
make the remaining installation easier. Repeat this procedure
on the other side of the vehicle. When both sides are in posi-
tion, torque the nuts evenly to the torque specified in rear block installation kit instructions.
46) Reroute the emergency brake cable to the underside of the leaf springs and reattach the cables at
the drum backing plates.
47) Connect the proportioning valve link (90-1347) as shown using the OEM bolts on the bottom, and the
provided hardware on the top. See ILLUSTRATION 29.
48) Remove the ABS wiring bracket from the differential and install the ABS wiring extension (90-1083)
ILLUSTRATION 30
Original configuration of
emergency brake cable
ILLUSTRATION 31
Configuration of
emergency brake cable
after modification
ILLUSTRATION 32
PN 90-1083