Owners manual

19
57095
Revised
2.28.2008
as shown in ILLUSTRATION 32. Use the OEM bolt at the lower end and the supplied hardware at the
top. Reconnect the ABS wire loom to the frame connector and reattach the loom to the gas tank.
49) Check all hardware at this time to ensure that everything is tight. Check for adequate clearance on
all repositioned brake lines and emergency brake cables. Make sure you check with the suspension fully
extended, and compressed.
50) Reinstall the tires, remove jack stands and lower to the ground.
• AFTER INSTALLATION IS COMPLETE:
• Re-check and tighten/torque all fasteners. See torque specifications chart.
• Re-check brake/steering systems. Be sure all hoses are long enough. Make sure there are no
clearance/binding problems.
• Re-adjust headlights.
• Front end alignment is needed after installation. Set alignment to factory specs.
• Bleeding brakes and steering should be done according to the Toyota Tacoma service manual
(page SR-10 and BR-1).