Owners manual

5
57095
Revised
2.28.2008
PRIOR TO INSTALLATION:
• Installation by a professional mechanic is recommended. Use of the appropriate
power tools, a Toyota Tacoma service manual and a shop hoist can greatly reduce in-
stallation time.
• Check the production date of your vehicle. Vehicles manufactured prior to 10/95
may require additional parts to complete installation. If the front end alignment cams
measure 1.85” in diameter, contact your Toyota Dealer for the cam bolts that are used
on the 10/96 or later production vehicles or contact Pro Comp Suspension for adapter
parts.
• Read the instructions carefully and study the illustrations before attempting instal-
lation. Pro Comp Suspension is not responsible for damage, failure or injury resulting
from improper installation or parts substitution of this kit.
• Check all parts and hardware against the parts list to assure that your kit is com-
plete. The parts and hardware supplied are of high grade material and must not be
replaced by inferior parts or failure may result.
• Separating parts according to the areas they will be used and placing the hardware
with the brackets before you begin will save installation time.
• This kit is supplied as a bolt-on assembly. Do not weld anything to the components
and do not weld the components to the vehicle.
• All components in this kit come with a protective coating. Do not plate (i.e.
chrome, cadmium, zinc etc.) or otherwise alter the finish in anyway. This could
weaken the structural strength of the components.
• Always wear safety glasses when using power tools.
• Foot pound torque readings are listed on the Torque Specifications Chart at the
end of the instructions unless specifically stated in an instruction. DO NOT USE AN
IMPACT WRENCH TO TIGHTEN ANY OF THE BOLTS.
• Measure vehicle ride height.