Owners manual

57095

Revised

2.28.2008

1) Remove grease cap, cotter pin and locking cap (ILLUSTRATION 1). While applying brakes,

loosen axle nuts with a 35mm socket. Do not remove at this time.

2) Block rear wheels, set parking brake, raise front of vehicle and support with jack stands. Do not

work on any vehicle unsupported by jackstands. Remove front wheels, tires and O.E.M. skid plates.

3) Place a jack under front lower a-arm. Remove lower nut from front shock mount. Next, locate the

three (3) nuts at the top of the front shock (ILLUSTRATION 2). Remove these nuts. Lower a-arm and

remove front shock. Repeat step 3 on the opposite side.

4) Locate and remove the nut, retainer collar and cushion that attaches the sway bar end to lower a-

arms (ILLUSTRATION 3). Remove the two brackets that attach the sway bar to the frame.

(ILLUSTRATION 4) Set this assembly aside.

5) Detach bolt and brake line hose clamp from the front spindle (ILLUSTRATION 5). Next remove

Front Installation:

ILLUSTRATION 2 ILLUSTRATION 1

ILLUSTRATION 3

ILLUSTRATION 4