Owner's Manual

Table Of Contents

#2 Phillips screwdriver, Dash Trim Removal Tool (DM-40-22), 5/64” drill bit and drill

Pro.Fit VSM G3, two # 8 x 1/2” screws

Right of radio

TOOLS REQUIRED:

PARTS INCLUDED:

LOCATION:

STEP 1.

Insert the dash trim removal tool behind the trim bezel,

above the right air vent. (Photo # 1). Pry outward to

release a retainer clip. Work the removal tool counter-

clockwise around the bezel until all clips are released.

Disconnect the wire harness on the back side of the bezel.

Set bezel aside.

STEP 2.

Place the Pro.Fit VSM G3 against the dash pad above the

right corner of the radio, aligning the bottom of the G3

with the small ledge . (Photo # 2). Using the G3 as a

guide, mark the location of two (2) screw holes. Set G3

aside. Drill two (2) pilot holes at the marked location using

a 5/64” drill bit and drill. Align the G3 over the pilot

holes, insert two (2) # 8 x 1/2” screws and tighten.

STEP 3.

Re-assemble the dash in reverse order, remembering to

reconnect the wiring harness. This completes the

installation of your Pro.Fit VSM G3.

Align Here

012406-04

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit VSM G3.

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal

of this Pro.Fit VSM G3

. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876

VIEW INSTRUCTIONS & UPDATES

ONLINE

WWW.PRO-FIT-INTL.COM

PART NUMBER: IF-71-03-G3

Chevrolet Colorado (2004-2006)

GMC Canyon (2004-2007)

Isuzu i-Series Pickups (2004-2007)

Page 2