Owner's Manual

Table Of Contents

#2 Phillips screwdriver, Dash Trim Removal Tool (DM-40-22), 5/64” drill bit and drill,

protective cloth

Pro.Fit VSM G3, two # 8 x 1/2” screws

Right of radio

TOOLS REQUIRED:

PARTS INCLUDED:

LOCATION:

091305--01

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit Legend.

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal

of this Pro.Fit VSM G3

. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876

VIEW INSTRUCTIONS & UPDATES

ONLINE

WWW.PRO-FIT-INTL.COM

PART NUMBER: IF-71-03-G3

Chevrolet Aveo (2004-2006)

Remove Panels

STEP 1. Insert the dash trim removal tool behind the upper

corner of the trim bezel left of the radio. (Photo # 1). Pry

outward to release a retainer clip. Work the trim tool

downward to release a second clip. Set bezel aside and

remove the right trim bezel in the same manner.

STEP 2. Remove four (4) 10mm screws that secure the radio

and small compartment below it. They are located at the

upper corners of the radio and the lower corners of the

compartment. Slide the radio out of its cavity and

disconnect the antenna lead. DO NOT DISCONNECT THE

WIRING TO THE RADIO. If disconnected, you need to get

the radio code from a Chevrolet dealer to make the radio

operable. Wrap the radio with a protective cloth and let it

hang down on the left side.

STEP 3. Align the G3 left of the small compartment. (Photo

# 2). Using the G3 as a guide, mark the location of two (2)

screw holes. Set G3 aside. Drill two (2) pilot holes at the

marked location using a 5/64” drill bit and drill. Align the

G3 over the pilot holes, insert two (2) # 8 x 1/2” screws and

tighten.

STEP 4. Re-assemble the dash in reverse order,

remembering to reconnect the radio antenna. This

completes the installation of your Pro.Fit VSM G3.

Page 3