Owner's Manual

Table Of Contents

#2 Phillips screwdriver, Dash Trim Removal Tool (DM-40-22), 5/64” drill bit and drill,

protective cloth

Pro.Fit VSM G3, two # 8 x 1/2” screws

Right of radio

TOOLS REQUIRED:

PARTS INCLUDED:

LOCATION:

STEP 1. Apply parking brake and place gear shift into

neutral. Insert the dash trim removal tool behind the trim

bezel, above the upper-right corner of the radio. (Photo 3).

Pry outward to release a retainer clip. Work the removal

tool counter-clockwise around the bezel until all clips are

released. Disconnect the wire harness on the power port.

Do Not disconnect climate control wiring. Let bezel hang

down.

STEP 2. Remove the four (4) 7mm bolts that secure the

radio. (Photo1). There is one (1) at each corner. Slide the

radio out of its cavity and let hang down. Do Not

disconnect radio wiring.

STEP 3. Place the Pro.Fit VSM G3 against the right side of

the radio cavity. (Photo 2). Using the G3 as a guide, mark

the location of two (2) screw holes. Set G3 aside. Drill two

(2) pilot holes at the marked location using a 5/64” drill bit

and drill. Align the G3 over the pilot holes, insert two (2) #

8 x 1/2” screws and tighten.

STEP 4. Re-assemble the dash in reverse order,

remembering to reconnect the wiring harness. This

completes the installation of your Pro.Fit VSM G3.

082505-01

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit Legend.

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal

of this Pro.Fit VSM G3

. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876

VIEW INSTRUCTIONS & UPDATES

ONLINE

WWW.PRO-FIT-INTL.COM

PART NUMBER: IF-71-03-G3

Ford Focus (2005-2007)

7mm Bolts

Page 4