Owner's Manual

#2 Phillips screwdriver, Dash Trim Removal Tool (DM-40-22), 5/64” drill bit and drill,
protective cloth
Pro.Fit VSM G3, two # 8 x 1/2” screws
Right of radio
TOOLS REQUIRED:
PARTS INCLUDED:
LOCATION:
1
2
3
091305-00
PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit Legend.
All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling
wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal
of this Pro.Fit VSM G3
V
. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.
Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876
© Pro.Fit International, Eagan, MN 2008
VIEW INSTRUCTIONS & UPDATES
ONLINE
@
WWW.PRO-FIT-INTL.COM
PART NUMBER: IF-71-03-G3
Ford Explorer (2007-2008)
7 mm
STEP 1. Apply parking brake and place gear shift into drive. Open
center arm rest and remove two (2) 7mm bolts from the front of the
console. Photo 1. Insert the dash trim tool behind the gear shift
trim bezel. Press down to release a retainer clip. Work the tool
around the trim until all clips are released. Lift ring over gear shift
and set aside.
STEP 2. Insert the trim tool behind the cup holder / shifter bezel
near the 7mm bolt holes. Press down to release a clip. Work the
tool around the bezel until all clips are free. Lift bezel over shifter,
disconnect wiring and set bezel aside. Photo 1.
STEP 3. Insert trim tool behind the upper-right corner of the radio
bezel. Press down gently to release a clip. Work the tool around the
bezel until it is completely free. Very carefully disconnect the
wiring and vacuum lines from the bezel. Set bezel aside.
STEP 4. Remove four (4) screws from the corners of the radio. Pull
radio out of its cavity, wrap protective cloth around radio and let it
hang down. Do Not disconnect radio wiring.
STEP 5. Place the Pro.Fit VSM G3 against the right side of the radio
cavity, aligning it just above the clip hole. (Photo 2). Using the G3
as a guide, mark the location of two (2) screw holes and G3 top. Set
G3 aside. Using a utility knife, trim the small ridge behind the G3
so it sits tight against the dash pad. Drill two (2) pilot holes at the
marked location using a 5/64” drill bit and drill. Align the G3over
the pilot holes, insert two (2) # 8 x 1/2” screws and tighten.
STEP 6. Re-assemble the dash in reverse order, remembering to
reconnect the wiring harness. This completes the installation of your
Pro.Fit VSM G3.
Page 6