Owner's Manual

Table Of Contents

Page 8

Ford Escape 2008

Part Number: IF-71-03-G3

Step One:

Place the Dash Trim Removal Tool in the upper

right hand corner of the dash trim bezel, just to

the right of the radio display and air vent. There

are four (4) clips holding this bezel in place. Pop

each clip carefully and work the tool in a counter-

clockwise rotation around the dash bezel. After

releasing the clips, place the bezel carefully

aside.

Step Two:

Place the VSM G3 flush against the ridge of the

dash as shown in picture (1). Once you have the

VSM G3 in place, use the VSM G3 as a guide and

mark the location of the two mounting holes.

Using a 5/64” drill bit, carefully drill out the pilot

holes in the marked location. Place the VSM G3

over the marked location and tighten using the

provided screws. Reassemble the dash in reverse

order. This completes the installation of your

Pro.Fit VSM G3.

VIEW INSTRUCTIONS & UPDATES

ONLINE

WWW.PRO-FIT-INTL.COM

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal

of this Pro.Fit VSM G3

. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876

Tools Needed:

Parts Included:

Location:

Dash Trim Revmoval Tool (DM-40-22), 5/64” Drill Bit and Drill

Pro.Fit Legend, two # 8 x 1/2” screws

Right of Radio/Air vent

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit Legend.

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.