Owner's Manual

ManualsBrandsPro.Fit International ManualsApple & Android integrationPro.Fit VSM G3

Table Of Contents

Page 9

Dodge Sprinter 2008

Part Number: IF-71-03-G3

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit Legend.

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.

Tools Needed:

Parts Included:

Location:

Dash Trim Revmoval Tool, Star pattern screw driver, 5/16” drill, drill bit,

phillips screw driver.

Pro.Fit VSM G3, two # 8 x 1/2” screws

Right of Climate Control

Step One:

Begin by inserting the Dash Trim Removal Tool in the upper

right hand corner of the dash face bezel directly above the

radio. This plastic bezel is held on by a total of seven (7)

clips. After carefully popping open the first clip in the

upper right hand corner of the radio bezel, carefully work

open the bezel by removing each clip one at a time in a

clockwise rotation. There is a clip placed in the center of

the bezel right below the radio to take note of. After

removing the bezel carefully disconnect the wiring to the

bezel and set the bezel aside.

Step Two:

Once the bezel is set aside, the climate control pad must be

removed. The climate control is held in place by four (4)

star patterned screws. Remove these screws and pull the

climate control out of the dash. Do not disconnect the

climate control, and simply allow the climate control to

carefully hang down in front of the dash.

Step Three:

Place the VSM G3 in the location as instructed by photo #2.

Once the VSM G3 is in place, mark the pilot holes in the VSM

using a marker. Using a 5/16” drill bit, very carefully drill

the pilot holes over the area you have marked. Place the

VSM G3 over the drilled holes and secure the VSM to the

dash using the two (2) provided screws.

Step Four:

Once the VSM G3 is secured and in the correct position, put

the dash back together in the reverse order that it was

dismantled. You have successfully installed your Pro.Fit

VSM G3.

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal

of this Pro.Fit VSM G3

. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876

VIEW INSTRUCTIONS & UPDATES

ONLINE