Owner's Manual

INSTALLATION INSTRUCTIONS
LINCOLN NAVIGATOR (2003)
See other side for LINCOLN AVIATOR (2003)
PART NUMBER: LC-70-03
Pro.Fit
logo and part number will be right side up and readable when installed.
TOOLS REQUIRED: # 2 Phillips screwdriver, hook tool, 5/64” drill bit and drill, marking pen.
PARTS INCLUDED: Pro.Fit VSM
TM
, three (3) # 8 x 1/2” screws, instructions.
LOCATION: Right of radio.
STEP 1. Apply the emergency brake and put the gear shift into
neutral. Open the center console arm rest, located behind the gear
shift. There is a small button that has a push pin in its center. (See
photo # 1). Push the pin in with a small pointed object such as a
pen. This will release the retainer clip that holds the window switch
panel in place. Lift the panel off, disconnect the wiring and set
aside. Remove the two (2) 7mm screws from underneath the switch
panel. (See photo # 2). Work your hands or a hook tool around the
gear shift bezel until two (2) retainer clips, front left and right, are
released.
STEP 2. With the gear shift bezel turned slightly clockwise,
remove the two (2) 7mm screws from the back of the cavity directly
below the ashtray. (See photo # 3). The next step requires
extreme caution to avoid damage to the bezel. Insert a hook tool
behind the lower left corner of the radio trim bezel. The bezel has
four retainer clips, one on each side of the air vents, and one on each
side of the numbered radio push buttons. Work the hook tool
around the bezel to release all the clips. Disconnect the wiring and
set the bezel aside.
STEP 3. Align the Pro.Fit VSM
TM
against the dash pad as shown
in photo # 4. Using the VSM
TM
as a guide, mark the location of the
three (3) mounting holes. Set the VSM
TM
aside. Using a 5/64” drill
bit and drill, drill three (3) 1/2” pilot holes at the marked locations.
Position the VSM
TM
over the pilot holes, insert three (3) # 8 x 1/2”
screws and tighten. Reassemble the dash in reverse order. Place the
gear shift into park and release the emergency brake.
This completes the installation of your Pro.Fit VSM
TM
.
Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this
Pro.Fit VSM
TM
. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.
Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651-688-3588 or 800-388-0073 Fax: [phone]
Web Address: www.pro-fit-intl.com
© Pro.Fit International, Eagan, MN 2003
091302-00
PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit VSM
TM
.
All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling
wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
Button
Hook Tool
2 Screws
1
3
4
5
2
Switches
2 Screws
Lower right
radio bezel
clip hole