Owner's Manual

INSTALLATION INSTRUCTIONS

LINCOLN AVIATOR (2003)

PART NUMBER: LC-70-03

Pro.Fit

logo and part number will be right side up and readable when installed.

TOOLS REQUIRED: # 2 Phillips screwdriver, 5/64” drill bit and drill, Dash Trim Removal Tool (DM-40-22),

marking pen, 7mm nut driver.

PARTS INCLUDED: Pro.Fit VSM

, three (3) # 8 x 1/2” screws, instructions.

LOCATION: Right of air vent.

STEP 1. Locate the air vent on the top of the dash, next to the

windshield. The vent has five (5) retainer clips, one (1) in each

corner, and one (1) between the two corners nearest the windshield.

Pry the vent upwards to release the clips with the dash trim removal

tool. Set vent aside. Removing the vent will reveal two (2) 7mm

bolts in the vent cavity. Remove these bolts.

STEP 2. Insert the trim tool behind the lower-left corner of the

radio bezel. Pry slightly outward to release a clip. Grasp the corner

of the bezel and work your hands around it, to release the remaining

two (2) clips. (Photo # 1). Set the bezel aside. Next, remove the

center vent & clock assembly by prying outward with the dash trim

removal tool. The center vent has four (4) clips, one in each corner.

Do not disconnect any wiring to the clock.

STEP 3. Rest the Pro.Fit VSM on top of the climate control as

shown in photo # 2. The back edge of the VSM should be against

the dash pad. Using the VSM as a guide, mark the location of the

three (3) mounting holes. Set the VSM aside. Using a 5/64” drill

bit and drill, drill three (3) 1/2” pilot holes at the marked locations.

Drill pilot holes ONLY 1/2” deep to avoid drilling completely

through the dash pad. Position the VSM over the pilot holes,

insert three (3) # 8 x 1/2” screws and tighten. Reassemble the dash

in reverse order. Place the gear shift into park and release the

emergency brake.

This completes the installation of your Pro.Fit VSM.

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this

Pro.Fit VSM

. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651-688-3588 or 800-388-0073 Fax: 651-688-9876

Web Address: www.pro-fit-intl.com

021803-00

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit VSM

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.

Clips

See other side for LINCOLN NAVIGATOR (2003)