Owner's Manual

INSTALLATION INSTRUCTIONS
LEXUS ES300 (2002-2003)(with or w/o GPS)
(See reverse side for LEXUS LS430 (2001-2003) )
PART NUMBER: LX-52-01
WARNING: Place a clean, protective cloth over the gear shift lever
before starting this installation. Use extreme caution while working
on this vehicle. It has wood grain panels that scratch very easily!
STEP 1. Begin by setting the parking brake and putting the gear
shift into neutral. Remove the gear shift bezel by inserting a hook
tool behind the lower left corner and pulling up gently, releasing a
retainer clip. There are eight (8) clips holding the bezel in place.
(See photo # 1). Work the hook tool from back to front until all
clips are released. Lift the trim bezel over the gear shift and set to
the side. Do not disconnect any wiring to the bezel.
STEP 2. Next, remove the climate control from the dash. The
climate control is held in place with five (5) clips. There is one in
each corner and one at the top and center of the climate control.
Insert a hook tool behind the lower left corner of the climate
control and pull outward, releasing a clip. These clips are very
tight, so they will not release as easily as the bezel clips did. Work
a hook tool around the climate control, pulling outward, until all
the clips are released. Pull the climate control out of its cavity and
set to the side. DO NOT disconnect the wiring to the climate
control.
STEP 3. Place the VSM
TM
against the dash pad as shown in
photo # 2. The top of the VSM
TM
will touch the bottom radio
module. Using the
VSM
TM
as a guide, mark the location of the
three (3) screw holes. Drill three (3) pilot holes at the marked
location using a 5/64” drill bit and drill. These holes should be
no more than 1/4
”
deep. Align the Pro.Fit VSM
TM
over the pilot
holes, insert three (3) # 8 x 1/2” screws and tighten. Reassemble
the dash in reverse order. Put the gear shift into park and release
the parking break.
This completes the installation of your Pro.Fit VSM
TM
.
Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this
Pro.Fit VSM
TM
. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.
Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651-688-3588 or 800-388-0073 Fx: 651-688-9876
Web Address: www.pro-fit-intl.com
© Pro.Fit International, Eagan, MN 2003
102202-07
PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit VSM
TM
.
All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling
wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
VIEW INSTRUCTIONS & UPDATES
ONLINE
@
WWW.PRO-FIT-INTL.COM
1
3
2
Pro.Fit logo and part number will be right side up and readable when installed.
TOOLS REQUIRED: # 2 Phillips screwdriver, hook tools, protective cloth, 5/64” drill bit and drill, marking pen.
PARTS INCLUDED: Pro.Fit VSM
TM
, instructions, three (3) #8 x 1/2” screws.
LOCATION: Right of Climate Control.
Radio Clips