Technical Specifications

HEARTHMASTER
™
Log Lighter Kit
HM-LLKINS-0119P
Pro-Flex, LLC 877-798-6291 www.proflexcsst.com
Temperature Ratings:
Minimum: 32ºF / 0ºC
Maximum: 125ºF / 51.6ºC
½" Pipe Union
Hearth
Master
Valve
Lever-type Valve
½" Gas Pipe
½" Gas Pipe
HearthMaster Valve
½" Gas Pipe
½" Pipe Union
Flange
1¼" Hole1¼" Hole
½" Gas Pipe
½" Gas Pipe
Lever-type Valve
½" Gas Pipe
To Gas Source
To Gas Source
To Firebox
Angle Valve
Installation
952 Series
Straight Valve
Installation
954 Series
• Always follow ALL local building and plumbing codes during installation.
• Use only black gas pipe, and secure piping every fiv
e feet or less.
• Remove an
y
debris from male and female threads before connecting.
• Always use a pipe joint compound or P.T.F.E. pipe thread tape on all
connections to seal threads.
Log Lighter Valve Installation Instructions
1. Turn off the gas line to the firebox or, if necessary, the main gas line.
2. Determine which side of the firebox the valve will be installed. Drill a 1¼" hole for the flange and
valve. Thread the valve into the flange from below the floor or behind the wall.
3. Run ½" rigid gas pipe from the valve, and extend approximately 3½" into the firebox if coming
from the side, or 1½" if coming from below. Cap off firebox stub with threaded ½" cap.
4. Run ½" gas pipe from the gas source to a ½" lever-type ball valve. (This valve is not the same
as a HearthMaster valve.)
5. Run ½" gas pipe from the lever-type ball valve to a ½" gas pipe union.
6. Run ½" gas pipe from the HearthMaster valve to the union, and thread union together. Test all
new connections with a liquid leak detector.
Log Lighter Bar Installation Instructions
For Natural Gas Only
1. Turn off the gas line to the firebox or, if necessary, the main gas line.
2. Center the
log lighter bar in the firebox, directly under flue or chimney. Remove stub out cap or old log
lighter bar, if necessary.
3. Connect log lighter bar to gas supply using ½" nom. black gas pipe (as shown).
4. Seal unused ½" FIP gas inlets with threaded plugs provided.
Log Lighter Ignition
1. Make sure log lighter valve is completely turned off. Make sure chimney damper or flue is open.
2. Arrange wood loosely on log grate above log lighter bar.
3. Crumple paper and place under log lighter bar. Light paper.
4. Turn log lighter valve on until bar ignites.
5. Adjust log lighter valve until desired flame setting is reached.
6. Turn log lighter valve off after logs have started to burn.
WARNING: Cancer and Reproductive Harm
ADVERTENCIA: C
áncer y Daños Reproductivos
ADVERTISSEMENT: Cancer et effets néfastes sur la reproduction
www.P65Warnings.ca.gov
To Gas Source
½" Gas Pipe
½" Gas Pipe
½" Gas Pipe
½” Plug (provided)
½" Plug (provided)
½" Plug (provided)
To Gas Source
To Gas Source
Right Side
Left Side
B
ottom