User`s manual

11. Remove the screw and the cover from the back

of the Console (9).

Remove the paper from the adhesive pad on

the back of the receiver. Press the receiver onto

the indicated location inside the cover.

Connect the wire on the receiver to the wire in

the Console (9). Then, reattach the cover with

the screw.

Note: Discard any other wires that are included

with the heart rate monitor.

If you purchase the optional heart rate monitor (see page 22), follow the additional step below to install

the receiver included with the heart rate monitor.

Wires

Receiver

Cover

Screw

Attach

receiver

here

9. Locate the Upper Wires (68) inside the

Handlebar (7).

hile a second person holds the Console (9)

near the Handlebar (7), connect the wires on

he Console to the Upper Wires (68). Then,

insert the wires into the Handlebar.

Tip: Avoid pinching the wires. Slide the

Console (9) onto the Handlebar (7).

Attach the Console (9) with four #8 x 3/4"

Screws (94).

10. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly

is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.

Avoid pinching

the wires

Cover