Operation Manual

11
12. Attach the Water Bottle Holder (37) to the
Upright (4) with two M4 x 16mm Screws (104).
37
4
104
104
13
13. Untie and discard the wire ties on the Wire
Harness (111) and the Pulse Wires (63).
While a second person holds the Console (7)
near the Upright (4), connect the wires on the
Console to the Wire Harness (111) and to the
Pulse Wires (63).
Insert the excess wire downward into the
Upright (4).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Upright (4) with four M4 x
16mm Screws (104).
See step 3. Tighten the M8 x 19mm Patch
Screws (82).
7
63
111
104
4
Avoid pinching
the wires
15. Make sure that all parts are properly tightened before you use the elliptical. Note: After assembly is com-
pleted, some extra parts may be left over. Place a mat beneath the elliptical to protect the floor.
14. Plug the Power Adapter (112) into the recepta-
cle on the front of the elliptical.
If necessary, plug the Power Adapter (112) into
the Plug Adapter (122).
To plug the Power Adapter (112) into an outlet,
see HOW TO PLUG IN THE POWER
ADAPTER on page 13.
14
112
122
12