Operation Manual

21
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first use a flat screwdriver to
rotate the left disc counterclockwise. Then, remove the
left disc from the left disc mount.
Next, locate the Reed Switch (38). Turn the Pulley
(19) until one of the Magnets (43) on the Pulley is
aligned with the Reed Switch. Loosen, but do not
remove, the M4 x 16mm Reed Switch Screw (69).
Slide the Reed Switch (38) slightly closer to or away
from the Magnet (43). Then, retighten the Reed Switch
Screw. Turn the Pulley (19) for a moment. Repeat
these actions until the console displays correct feed-
b
ack.
Reattach the left disc by rotating it clockwise into the
left disc mount.
HOW TO GREASE THE ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Rollers (51) squeak when moving on
the Ramp (3), apply a small amount of white marine
grease equally to each Roller. Spread the grease
evenly around the Rollers. Pedal the elliptical until a
thin film of grease is distributed along the Ramp; then,
wipe off any excess grease.
43
38
69
19