Operation Manual

11
2. Make sure that the power cord is unplugged.
Have two other persons hold the Uprights (116)
near the brackets on the Base (104) as shown.
Remove the tie securing the upright wire (A).
Connect the upright wire (A) to the base wire
(B). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
2
116
104
A
B
B
A
3. Slide the Uprights (116) onto the Base (104). Be
careful not to pinch the wires (not shown) in
the right Upright.
Attach the Uprights (116) with eight 3/8" x 1"
Screws (4) and eight 3/8" Star Washers (5) (only
one Upright is shown). Start all eight Screws,
and then tighten them.
3
116
4
5
104
5
4