User`s manual

10
11. Lower the Uprights (38, 39) as shown.
See the lower drawing. Position the Uprights (38,
39) so that the treadmill Frame (36) is centered
between them.
Firmly tighten the Upright Bolts (4) on each side
of the treadmill.
Important: If there is a thin sheet of plastic on
the bottom of the Belly Pan (49), remove the
plastic.
39
38, 39
36
38
View from Above
Side View
11
4
2
10. Insert the connectors and the excess wire into
the Console Base (67) as you set the Console
Base on the Handrails (40).
Make sure that no wires are pinched, and
s
tart two Console Bolts (2) with 1/4" Star
W
ashers (8) into the Handrails (40) and the
Console Base (67). Do not tighten the Console
Bolts yet. Next, start four 3/4" Screws (3) into
the Handrails and the Console Base. Tighten
the Screws and then tighten the Console
Bolts; be careful not to overtighten the
Screws.
3
2
8
8
3
40
4
0
10
67
Front View
12.
Attach the ground wire on the Upright Wire (69)
to the indicated hole in the Base (37) with a No.
8 x 3/4” Screw (10).
Press the indicated Grommet (72) into the Right
Upright (39).
37
69
39
72
10
Ground
Wire
12
49