User`s manual

3. Carefully raise the Left Upright (38) and Right

Upright (not shown).

Attach the Latch Housing (91) to the Left Upright

(

38) with two 3/4” Screws (3).

ake sure that

the large hole in the Latch Housing is on the

ide shown. Do not overtighten the Screws.

Remove the knob from the pin. Make sure that

the collar and the spring are on the pin. Insert

the pin into the Latch Housing (91), and tighten

the knob back onto the pin.

15. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may

be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt

(see page 23). To protect the floor or carpet, place a mat under the treadmill.

Knob

Collar

Spring

Large

Hole

14. Attach the Left Upper Body Arm (42) to the left

Upright (38) with two 3 1/2” Bolts (33), two Flat

Washers (29), and two Upright Star Washers (6)

as shown.

Make sure that the Left Upper Body

Arm is on the indicated side of the Console

Base (67).

Attach the Right Upper Body Arm (not shown) to

the Right Upright (not shown) in the same way.