User`s manual

5. While another person holds the Console (5) near the

Console Bracket (26), connect the wire harness on

he Console to the Upper Wire Harness (79). Insert

the Upper Wire Harness down into the Console

racket.

Attach the Console (5) to the Console Bracket (26)

with four M4 x 16mm Screws (66). Be careful to

avoid pinching the wire harness.

Attach the Water Bottle Holder (63) to the Upright (2)

with two M4 x 19mm Screws (39).

Wire

Harness

6. While another person holds the Upright (2) near the

Frame (1), connect the Upper Wire Harness (79) to

the Lower Wire Harness (65). Next, connect the

Resistance Cable (61) to the Lower Cable (55) in the

following way:

• See drawing A. Pull up on the metal bracket on the

Lower Cable (55), and insert the tip of the

Resistance Cable (61) into the wire clip inside of the

metal bracket.

• See drawing B. While another person pulls up on

the Upright (2), slide the Resistance Cable (61) into

the metal bracket on the Lower Cable (55) as

shown.

• See drawing C. Using pliers, squeeze together the

prongs on the upper end of the metal bracket.

Set the Upright (2) on the Front Stabilizer (3) and the

Frame (1).

Be careful to avoid pinching the Cables

(55, 61) and the Wire Harnesses (65, 79).

Align the

holes in the Upright with the holes in the Front

Stabilizer and the Frame.

Carefully tip the elliptical exerciser onto one side, and

attach the Upright (2) to the Front Stabilizer (3) and

the Frame (1) with four M10 x 58mm Button Screws

(19) and four M10 Split Washers (67).

7. Gently separate the Left and Right Frame Covers (30,

81). Hold the Frame Covers around the Upright (2)

and the Frame (1). Firmly press the Frame Covers

together.

B C

Metal

Bracket