User manual

GPX Pro 36

1.8.1.2 Wiring with Scotchlok Connectors

Included with your GPX Pro is a set of Scotchlok connectors that can be pressed onto your wires

with no stripping or soldering required. Supplied initially are 6 of these connectors in order to

begin wiring your vehicle to collect data. More Scotchloks and color-coded wiring can be

purchased in our DAQ Wire Kits at www.xtracing.com. All wire used with Scotchlok connectors

must be 22-16 AWG. We have found that most vehicles use wiring within this range. Make sure

that the metal tab in each Scotchlok is pressed down firmly over both wires before you close the

Scotchlok. There should be no bowing of the cap when you try to close it. If your cap appears

bowed, then your Scotchlok is not fully engaged and your GPX may not record your data.

GOOD:

BAD: