Manual

Inputs

The inputs In1 (RCA/phono sockets) and In 4 (XLR sockets) provide higher gain. They are dedicated to

sources with low level output signal, e.g. phono preamplifier, tape deck, or FM tuner. The inputs In 2 and In

3 (RCA/phono sockets) as well as In 5 and In 6 (XLR sockets) are suited to high level output sources like CD

player, D/A converter, or streamer.

Mains power connection

Connect the low voltage plug from the power supply to the Power 18-20V



socket before connecting the

power supply to the mains.

Remote control

turns the unit on or back into standby

and adjust the sound volume

and select the inputs

Front panel controls

To switch on from standby or to standby

The switch on the left hand side of the front panel turns the unit on or back into standby. The blue LED above

the stand-by switch shows that the unit is switched on.

After switching on, the tubes need a short time to reach the correct operating temperature. During

warm up the blue LED above the stand-by switch is blinking.

We recommend to set the volume control to 0, prior to switching on.

Input selector

After the unit is powered on, operating the switch next to the six LEDs selects the inputs. The selected input

will be shown by the corresponding LED.

Volume

Adjust the volume to the desired level, using the large knob on the front panel.

CH+

CH-

VOL+

VOL-

ON/OFF

VOL