INSTRUCTIONS FOR USE Pro-Ject Essential/Phono USB
14 10 22 1 9 2 44 14 4 8 77 66 7 5 3 66 6 11 14 13 12 Controls, features and connections 1 Power switch 2/22 Stepped drive pulley and drive belt * 3 Platter with felt mat * 4/44 Tonearm counterweight * and counterweight support rod 5 Tonearm lift lever 6/66 Tonearm rest and removable transport locks 7/77 Tonearm tube with tonearm bearing housing and red coloured transport lock 8 Anti-skating weight adjustment scale 9 Anti-skating weight support hoop 10 Anti-skating weight w
Pro-Ject Essential/Phono USB Dear music lover, thank you for purchasing a PRO-JECT AUDIO record player. In order to achieve maximum performance and reliability with this record player you should study these instructions for use carefully. ! Warning of a hazard for the user, the unit or possible misuse. Important notice. The record player is supplied with a factory fitted and adjusted cartridge.
Anti-skating force adjustment Hang the loop of the thread of the anti-skating weight in the groove of the anti-skating stub (8) corresponding to the downforce applied to your cartridge and feed the thread through the loop of the wire support (9).
Useful tips The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board to avoid structural vibrations disturbing replay. Switching on and off Pressing the power switch (1) alternately starts or stops the motor. Changing replay speed Put the belt (22) over the larger diameter part of the motor pulley (2). To revert to 33 r.p.m. repeat the proceedings using the smaller step on the pulley. When the Pro-Ject Speed Box is used speed change between 33 and 45 r.p.
Technical specifications Pro-Ject Essential/Phono USB / Pro-Ject 8.6 UniPivot Nominal speeds Speed variance Wow and flutter Signal to noise Effective tonearm mass Effective tonearm length Overhang Power consumption Outboard power supply Dimensions (W x H x D) Weight 33/45 r.p.m.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
Accessories Lid Red coloured transport lock Two tonearme transport locks Tonearm counterweight 8 Power supply © Audio Trade GmbH · Pro-Ject Essential / Phono USB / Pro 8.6UP / Ortofon OM 5E · Revision 2013.3.
