INSTRUCTIONS FOR USE Pro-Ject Record Box E
Dear music lover, thank you for purchasing a Pro-Ject Audio Systems Record Box E. In order to achieve maximum performance and reliability you should study these instructions for use carefully. ! Warning of a hazard for the user, the unit or possible misuse. Important notice. Safety instructions AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.
Mains power connection Connect the low voltage plug from the power supply to the Power 18V DC socket of the phono amplifier before connecting the power supply to the mains. Connecting to a Computer Connect the USB-output of the unit to a free USB-socket on your computer and turn it on/make sure it is powered on. The “new hardware found assistant“ will automatically detect the unit and announces it as a Microphone USB audio codec. There is no need to install a driver manually.
Potential incorrect use and fault conditions No signal on one or both channels: No connection between player and phono amplifier or amplifier. This could be due to a faulty plug, broken wire or solder joint or simply loose plug/socket connection. Strong hum: No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop. Output too quiet or too loud, or distorted: MM / MC mode incorrectly set - input overloading or insufficiently amplified.