INSTRUCTIONS FOR USE Pro-Ject “Hifi Airplay”-Set
Dear music lover, thank you for purchasing a Pro-Ject “Hifi Airplay”-Set. In order to achieve maximum performance and reliability you should study these instructions for use carefully. ! Warning of a hazard for the user, the units or possible misuse. Important notice. Safety instructions AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.
Connecting amplifier and speakers The output terminals accept loudspeaker cables terminated with 4mm Banana plugs, spades connectors or naked wire. Connect the cable terminals on the amplifier to the terminals on the speakers. The red speaker terminals carry the positive signal (+), the black speaker terminals the negative signal (–). Make sure the polarity of the connection is correct at each end of the cables. ! Only connect one loudspeaker with an impedance not less than 4 ohms per channel.
! 4 Never use any other power supply than the one supplied with the particular unit. © Audio Trade GmbH · Pro-Ject Hifi Airplay-Set · Revision 2013.4.
Remote control - Stereo Box S 1 ON/OFF ON/OFF CH+ 0_ and 0_ and VOL VOL+ VOL- turns the unit on or back into standby CH 0 adjust the sound volume 0 select the inputs VOL + CH + CH- Front panel controls - Stereo Box S Stereo Box S To switch on from standby or to standby - Stereo Box S The push button (press and hold to switch into standby mode) on the left hand side of the front panel turns the unit on or back into standby.
Front panel controls - DAC Box S USB DAC Box S USB To switch on from standby or to standby - DAC Box S USB The push button on the left hand side will toggle the DAC between its fully operational status and standby. The blue LED above the stand-by push button shows that the unit is switched on. If there is no input signal after the DAC got powered on, the unit switches through all inputs sequentially, until it detects a signal at one of the inputs.
Technical specifications Pro-Ject DAC Box S USB Line-level output: Output voltage: Digital outputs: USB-input: THD: Operating systems: D/A converter: Supported audio format: Sampling rates USB input: Optical and coaxial input: Outboard power supply: Power consumption: Dimensions W x H x D (D with sockets): Weight: 1 pair RCA/phono sockets 1Vrms 1 x coaxial (S/PDIF) 1 x optical (TOSlink®) 1 x USB (mini B socket) digital serial data protocol USB 1.