INSTRUCTIONS FOR USE Pro-Ject Stereo Box S
Dear music lover, thank you for purchasing a PRO-JECT AUDIO amplifier. In order to achieve maximum performance and reliability you should study these instructions for use carefully. ! Warning of a hazard for the user, the unit or possible misuse. Important notice. Connectors Record Out Left Right Left Right Pro-Ject Audio Systems, Vienna, Austria Make all connections whilst the amplifier is disconnected from the power supply. Take care to connect the left and right channels correctly.
Remote control 1 ON/OFF ON/OFF CH+ 0_ and 0_ and VOL VOL+ VOL- turns the unit on or back into standby CH 0 adjust the sound volume 0 select the inputs VOL + CH + CH- Front panel controls Stereo Box S To switch on from standby or to standby The push button (press and hold to switch into standby mode) on the left hand side of the front panel turns the unit on or back into standby. The blue LED above the stand-by push button shows that the unit is switched on.
Replacing batteries Proceed as follows: Unlock and slide open the battery case cover Replace the battery. Make sure the battery is the right way round ! Close the battery case cover Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at the appropriate collection sites - usually located at supermarkets and drugstores.
