Manual

Backlight

Turn on the stylus balance and the backlight will automatically switch on (no further key switch

needed). When the stylus balance is switched off, the backlight will switch off.

Other display readouts

No display, backlight getting weak - batteries are empty and need to be replaced.

o_LD - overload (more than 5g). Please remove the excessive load immediately.

LLLLL - The weighting load cell has been damaged by misuse (i.e. it was shocked, dropped or

overloaded). You can try to recalibrate the meter. If the load cell has not been damaged to

much, it will work again after recalibration.

UNSt - Use the meter on a more stable, vibration free surface.

Changing batteries

Proceed as follows:

• Take off battery case cover

• Replace both batteries together. Make sure the batteries are the right way round

• Refit the battery case cover

Battery type: 2 x LR43 (AG12) button cells, 1,5V

If the stylus balance is not used over a long period of time the batteries should be removed.

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted

batteries at the appropriate collection sites - usually located at supermarkets and

drugstores.

Technical specifications Measure it E

Capacity 0 - 5g

Variance ±0,002g

Weighting modes gram (1g = 10mN), ounce (oz), pennyweight (dwt) and carat (ct)

Display 4 digit LCD with backlight

Calibration auto calibration using a 5g weight

Auto off 30 seconds off

Replacement battery 2 x LR43 (AG12) button cells, 1,5V

Operating temperature +10 - +30 C (50 - 86 degrees Fahrenheit)

Dimensions (W x H x D) 96 x 21 x 43mm

Weight 49g

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these

instructions for use. Modification or change to any part of the product by unauthorized

persons, will release the manufacturer from any liability over and above the lawful rights of

the customer.

Pro-Ject Audio Systems is a Registered Trademark of

H. Lichtenegger.

This guide was produced by: Pro-Ject Audio Systems

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.