INSTRUCTIONS FOR USE Pro-Ject 1 Xpression Carbon Classic
© Pro-Ject Audio Systems · Pro-Ject 1 Xpression Carbon Classic / Ortofon 2M SILVER · Revision 2014.02.
Pro-Ject 1 Xpression Carbon Classic Controls, features and connections ® 1 Motor brackets with ORTOFON pads 2 Stepped drive pulley 3 Drive belt * 4 Hub 5 Platter * 6 Tonearm counterweight * 7 Tonearm lift lever 8/18 Tonearm rest and removable transport lock 9 Tonearm tube 10 Lid * 11 Lid hinges 12 Hinge fasteners 13 Power supply socket 14 Phono output sockets and earth connection 15 Anti-skating weight adjustment scale 16 Anti-skating weight * 17 Anti-skating weight support
Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging. Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it. Fit the drive belt (3) around the hub (4) and the smaller diameter part of the motor pulley (2). Avoid getting sweat or grease on the belt as these will deteriorate the performance and reduce the belt's lifespan.
With the aid of a good magnifying glass adjust the needle until it is vertical in the groove (i.e. perpendicular to the record's surface). Ideally this should correspond to the top surface of the cartridge body being parallel to the record surface. When you are satisfied that the needle is vertical retighten the screw carefully.
Changing replay speed To play records at 45 r.p.m. first remove the platter (5). Using the accessory tool provided (3a), hook the belt (3) over the larger diameter part of the motor pulley (2). Refit the platter. To revert to 33 r.p.m. repeat the proceedings using the smaller step on the pulley. *** In addition, 78 r.p.m. is available after fitting a special pulley, which may be purchased as an optional extra. For detailed product information please refer to the Pro-Ject web site www.project-audio.com.
Technical specifications PRO-JECT 1 Xpression Carbon Classic/Pro-Ject 8.6cc EVO Nominal speeds Speed variance 33/45 r.p.m.. *** 78 r.p.m. optional 33: 0,2% 45: 0,18% Wow and flutter 33: 0,14% 45: 0,13% Signal to noise 68dB Effective tonearm mass 6g Effective tonearm length 8,6 " (218,5mm) Overhang 18,5mm Power consumption 4W/ 0W standby mode Outboard power supply 15V / 0 - 0.8mA DC (set at 0.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
© Pro-Ject Audio Systems · Pro-Ject 1 Xpression Carbon Classic / Ortofon 2M SILVER · Revision 2014.02.